Pro Microphones / Pro-Microphones

Rode NT6 Compact Microphone

RODE NT6 Compact Microphone

The RODE NT6 is specifically designed for difficult mounting applications. Although clearly relevant to instrument mic'ing, the new NT6 is extremely well suited to any situation where a small 'unobtrusive' but powerful microphone system is required.

The 1/2" (externally biased) gold sputtered capsule is designed to attach to a custom made, multi-position swivel mount allowing it to be independently positioned with ease. The capsule is connected to the remote pre-amplifier (body) by a custom 3m KevlarŪ fibre reinforced cable.

The surface-mount pre-amplifier circuit also incorporates a two position variable pad: 0 dB an -10 dB attenuation, and a 2-position variable high-pass filter that enables you to step from a flat response to 80 Hz high pass filter; both conveniently located away from the capsule, providing additional control without the need to move the capsule once in position.

• Externally biased condenser
• Gold sputtered 1/2" capsule
• Two position PAD - 0dB and -10dB
• Two position High-Pass Filter - flat and 150Hz
• Convenient two-axis swivel mount and 3m KevlarŪ fibre reinforced cable included
• Heavy-duty satin-nickel plated body
• Surface mount circuitry
• Low noise and full frequency response

Specfications

Power	P48 (48V), P24 (24V) phantom supply
Acoustic Principle	Pressure gradient
Directional Pattern	Cardioid
Frequency range	40Hz-20kHz, selectable HPF @ 80Hz/12dB/octave
Output impedance	200ohm
Signal noise ratio	75 dB SPL (A - weighted per IEC651)
Equivalent noise	19 dB SPL (A - weighted per IEC651)
Maximum SPL	135dB SPL (@ 1kHz, 1% THD into 1Kohm load) (145dB with maximum PAD)
Maximum output voltage	+6dBu (@ 1kHz, 1% THD into 1Kohm load)
Sensitivity	-37 dB re 1 Volt/Pascal (16 mV @ 94 dB SPL) +/- 2 dB @ 1kHz
Weight	600gm
Dimensions	188.4mmH x 64mmW x 20mmD